FORD F-150 Super Crew Coolant hose/pipe replacement

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your FORD F-150 Super Crew.

Consult your mechanic for the specific parts required for your vehicle.

Coolant hose/pipe replacement on a FORD F-150 Super Crew typically takes 1–3.5 hours of labour at a garage.

For a FORD F-150 Super Crew, coolant hose/pipe replacement is typically needed coolant hoses should be inspected every 40,000–60,000 miles for cracking; replacement is on failure or visible deterioration.

A coolant flush involves draining the system, flushing it clean and refilling with the correct coolant type and concentration. Coolant itself costs $20–$50 for most vehicles; the job should take 30–60 minutes. Total cost of $80–$160 is typical. Be sceptical of a full machine flush being recommended on a car with clean, recent coolant — a simple drain-and-fill is often sufficient. More importantly, confirm the correct coolant type is being used for your FORD: mixing OAT, HOAT and IAT coolants causes corrosion and silting that can damage the water pump and radiator.

An independent is the right choice for most FORD vehicles. The critical thing is using the correct coolant type — your FORD owner's manual specifies the standard (OAT, HOAT, G11, G12, G13 etc). Any independent can source the correct coolant. Mixing coolant types causes corrosion regardless of who does the job, so confirm the garage knows the specification for your specific FORD engine. Dealer pricing for a coolant flush is typically 50–80% higher for the same outcome.

Brand matters less than type. FORD (like all manufacturers) specifies a coolant standard, not a brand — but using the wrong type causes real damage. Mixing OAT (orange/red, extended-life) with IAT (green, conventional) or HOAT creates a gel-like sludge that blocks small passages in the heater core and water pump. Always use the type specified in your owner's manual or stamped on the coolant reservoir cap. Quality brands including Prestone, PEAK, Zerex and Febi all produce coolants certified to manufacturer standards — check the label matches the requirement for your FORD.

A top-up adds a small amount of pre-mixed coolant to bring the reservoir to the correct level — appropriate when the level has dropped slightly, usually from minor evaporation. A flush replaces the entire coolant volume, restoring the corrosion inhibitors and freeze protection that degrade over time. Topping up old, degraded coolant with fresh coolant dilutes it slightly but does not restore full inhibitor protection. A proper flush is required every 2–5 years depending on the coolant type, regardless of how many top-ups have been done in between.

Fluid changes are manageable for a home mechanic with basic tools and care taken over correct disposal of old fluid. A garage will typically inspect related components at the same time, which adds value to a professional service over a DIY fluid swap.