FORD F-150 Super Crew Wheel bearing replacement

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your FORD F-150 Super Crew.

Common parts for this repair include: Wheel bearing.

Wheel bearing replacement on a FORD F-150 Super Crew typically takes 1–4 hours of labour at a garage.

For a FORD F-150 Super Crew, wheel bearing replacement is typically needed wheel bearings are replaced on failure; typical lifespan is 80,000–150,000 miles.

Wheel bearing cost varies significantly between press-fit and bolt-on hub assembly types. Press-fit bearings require a hydraulic press and specialised tooling; hub assemblies bolt straight on. Hub assemblies cost more in parts ($80–$250) but save press time. Get clarity on which type your FORD uses. For a press-fit bearing on an accessible location (front of most FWD cars), labour should be 1.5–2 hours. Be wary of a diagnosis based only on a road test — the jacked-wheel rock test and a stethoscope check while driving confirm which corner is faulty before any parts are ordered.

An independent with the correct press equipment is the right choice for most FORD wheel bearings. Press-fit bearings require a hydraulic shop press — confirm the independent has one before booking, as some small garages do not and may improvise incorrectly. Hub-type assemblies are simpler and can be done anywhere. If the bearing has an integrated ABS ring, confirm the new bearing includes the ring and that the ABS warning light is cleared after replacement. No FORD-specific software is needed for the bearing replacement itself.

Quality aftermarket wheel bearings are appropriate for most FORD models. FAG (Schaeffler), SKF, NSK and Timken are the leading bearing manufacturers and supply many OEM applications. Avoid very cheap unbranded bearings — bearing quality directly affects longevity and noise, and a cheap bearing can fail within 20,000 miles. For FORD models with integrated ABS wheel speed sensors in the bearing hub, confirm the replacement bearing includes the sensor ring and matches the OEM signal tooth count — the wrong count will cause an ABS warning light that cannot be cleared.

Both produce noise from the wheel area, but the pattern is different. A wheel bearing hum or growl changes pitch when you sway the car at moderate speed (weight transfers off the bad bearing, changing its load) — louder on right turns typically means the left bearing is failing. A CV axle click or pop is most prominent when turning at slow speed, particularly on full steering lock. CV axle noise also tends to appear under drive load (accelerating) and disappear on overrun. A diagnostic drive that includes sweeping at speed and slow tight turns will distinguish the two clearly.

At 1–4 hours of labour this repair requires a solid level of mechanical knowledge and the proper tools. Most owners prefer to use a professional to ensure the job is done correctly and backed by a parts-and-labour warranty.