FORD F-150 Super Crew Wheel speed (ABS) sensor replacement

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your FORD F-150 Super Crew.

Consult your mechanic for the specific parts required for your vehicle.

Wheel speed (ABS) sensor replacement on a FORD F-150 Super Crew typically takes 1–2.5 hours of labour at a garage.

For a FORD F-150 Super Crew, wheel speed (abs) sensor replacement is typically needed ABS components are replaced on failure; sensors typically last 80,000–120,000 miles.

ABS wheel speed sensor diagnosis should pinpoint the exact failed sensor using live data on a scan tool — the signal from each corner is monitored and the faulty one shows no signal or an erratic reading. An ABS sensor for most FORD models costs $20–$80; labour is 30–60 minutes. If you are quoted for the ABS hydraulic unit (the modulator) without a clear explanation, ask for evidence — modulator failures are much rarer and significantly more expensive. Confirm the sensor is faulty by live data comparison before replacement; a corroded connector or broken wire to a good sensor can mimic sensor failure.

An independent with a scan tool capable of reading live wheel speed data is the right choice. The diagnostic requirement is the ability to view each corner's signal in real time — not just reading the fault code. Most mid-range scan tools (Autel, Launch, iCarsoft) can do this. For ABS module or hydraulic unit replacement (which requires bleeding the brakes under computer control on some FORD models), confirm the independent has the bleed function in their software. Module replacement sometimes requires coding to the vehicle — check whether this is included.

Quality aftermarket ABS sensors are appropriate for most FORD models. Bosch, ATE, Delphi and Nissens manufacture sensors to OEM signal specifications. The key requirement is matching the correct tooth count for the ABS ring on your specific FORD wheel hub — using a sensor with the wrong tooth count calibration generates incorrect speed readings and cannot be cleared with a scan tool. For sensors that are integrated into the wheel bearing hub assembly (common on modern vehicles), the entire bearing hub is replaced as a unit; confirm the aftermarket bearing hub includes the correct integrated sensor ring.

ABS (anti-lock braking system) prevents wheels from locking during hard braking. Traction control (TC or TCS) prevents wheelspin during acceleration. Stability control (ESP/ESC) prevents the car from sliding out in corners. All three systems share the same wheel speed sensors and often the same control module — a failed wheel speed sensor typically triggers all three warning lights simultaneously. Diagnosing the root cause (usually a single sensor, wiring fault or ABS module issue) resolves all the warning lights at once. An ABS-only warning is different from all three lights appearing together.

At 1–2.5 hours of labour this repair requires a solid level of mechanical knowledge and the proper tools. Most owners prefer to use a professional to ensure the job is done correctly and backed by a parts-and-labour warranty.