FORD Fiesta 5 Doors Driveshaft replacement

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your FORD Fiesta 5 Doors.

Common parts for this repair include: Rear driveshaft, Front driveshaft.

Driveshaft replacement on a FORD Fiesta 5 Doors typically takes 1–4 hours of labour at a garage.

For a FORD Fiesta 5 Doors, driveshaft replacement is typically needed CV axles are replaced on failure; boots should be inspected at every service interval.

A remanufactured CV axle shaft for most front-wheel drive FORD models costs $60–$200. Labour is 1–2 hours per side. Be cautious if only a CV boot replacement is suggested when the joint already clicks audibly — once a CV joint is clicking, the grease has been contaminated and the joint is damaged; a full axle replacement is the correct repair. Also verify which side is failing with a slow-speed full-lock turn test before parts are ordered — the clicking corner is the affected side.

An independent is the appropriate choice for CV axle replacement on most FORD models. The job requires no FORD-specific software — it is a straightforward mechanical remove-and-replace. The key quality factor is using a reputable remanufactured or OEM-equivalent axle rather than a very cheap unit with poorly packed joints. Confirm the independent will use a quality brand rather than the cheapest available unit, as cheap CV axles can develop clicking within 20,000 miles.

Yes — remanufactured CV axles are the standard replacement. GSP, Cardone, Beck/Arnley and OEM-equivalent brands from reputable suppliers are widely used. Avoid the very cheapest options on online marketplaces — low-quality joints use inferior grease and thinner-walled housings that develop play and noise quickly. A mid-range remanufactured axle from a name-brand supplier will perform reliably for 80,000+ miles. Confirm the axle includes the correct spline count and length for your specific FORD model and year — variations exist within the same model range.

The CV boot is the rubber gaiter that seals grease into the CV joint and keeps dirt out. If the boot splits early (before joint damage occurs), replacing just the boot saves the cost of a full axle — it is a preventative repair. Once the boot has been split for a while (grease flung out, grit inside), the joint is contaminated and will develop the characteristic clicking sound. At that point, boot replacement alone is not sufficient — the full axle or individual joint must be replaced. The time to replace a boot cheaply is immediately when it splits and before any clicking develops.

At 1–4 hours of labour this repair requires a solid level of mechanical knowledge and the proper tools. Most owners prefer to use a professional to ensure the job is done correctly and backed by a parts-and-labour warranty.