MITSUBISHI ASX / RVR / Outlander Sport PCV valve replacement

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your MITSUBISHI ASX / RVR / Outlander Sport.

Common parts for this repair include: PCV valve.

PCV valve replacement on a MITSUBISHI ASX / RVR / Outlander Sport typically takes 0.5–2 hours of labour at a garage.

For a MITSUBISHI ASX / RVR / Outlander Sport, pcv valve replacement is typically needed every 40,000–60,000 miles as part of routine maintenance.

Always ask for an itemised quote showing parts cost and labour time separately. Research the cost of the specific parts required online — the part number is often readable from the old component. Compare the labour hours quoted against RepairFair's estimate for your specific MITSUBISHI model and year. A quote that is 20–30% higher than RepairFair's estimate warrants a second opinion. Ask whether aftermarket or OEM parts are being used, and whether a remanufactured option is available — both legitimate choices, but you should always know which one you are paying for.

For most repairs, a reputable independent with experience on MITSUBISHI vehicles is the better value choice — typically 30–50% less in total cost for the same quality outcome. The scenarios where a dealer makes sense are: work covered by a manufacturer or extended warranty, recalls or technical service bulletins requiring dealer-level software, and complex electronic programming that requires proprietary tools not yet available to independents. For mechanical repairs, an independent using quality parts is equivalent to a dealer in terms of outcomes and often exceeds dealer service in the attention given to each job.

Quality aftermarket parts from reputable tier-1 manufacturers are appropriate for most MITSUBISHI repairs. The distinction is between tier-1 aftermarket (Bosch, Denso, Delphi, Gates, SKF, Brembo — brands that supply car manufacturers as original equipment) and budget unbranded parts. Tier-1 aftermarket parts perform identically to OEM and often cost 30–60% less. The components where OEM is genuinely preferable are safety-critical items with tight tolerances (airbag modules, antilock brake modulators), items with MITSUBISHI-specific software coding (ECU, certain sensors), and components where the OEM part has been specifically improved over earlier versions that were prone to failure.

When any system component is replaced, it is worth inspecting nearby components that share labour time. Replacing one part while the relevant area is already disassembled often costs very little in extra labour compared with doing it as a separate job later. Ask your mechanic to inspect adjacent components and report their condition during the repair. Any part that is visibly worn or leaking and is accessible during the main repair is worth addressing at the same time — this is good planning, not upselling, when the mechanic can clearly show you the condition of the component in question.

At 0.5–2 hours of labour this is a relatively straightforward repair. A competent home mechanic with the right tools could attempt it, but a professional will road-test the car and inspect surrounding components to make sure everything is in order.