RAM Trucks 1500 Turbocharger repair/refurbishment

The cost varies by year, engine size, and your location. Use the estimator above for an accurate breakdown of parts and labour specific to your RAM Trucks 1500.

Consult your mechanic for the specific parts required for your vehicle.

Turbocharger repair/refurbishment on a RAM Trucks 1500 typically takes 3–8 hours of labour at a garage.

For a RAM Trucks 1500, turbocharger repair/refurbishment is typically needed turbos are replaced on failure; lifespan is highly dependent on oil change frequency and quality.

Turbo diagnosis must identify the root cause before replacement — a turbo that fails due to oil starvation (infrequent oil changes, blocked oil feed line) will destroy a new unit in the same way. Ask whether the oil feed and return lines have been inspected and whether they will be replaced. A quality aftermarket turbo for most RAM Trucks engines costs $300–$800; OEM units cost significantly more. Labour is 3–6 hours depending on engine configuration. If you are quoted a new OEM turbo without a remanufactured option, ask — quality aftermarket units are widely used in professional repairs.

A specialist independent with turbo experience on RAM Trucks engines is the best choice. Turbo replacement requires identifying and fixing the underlying cause of failure — oil change history, oil feed line condition and intercooler contamination must all be addressed. Dealers replace the unit but do not always investigate why it failed, leading to repeat failures. An independent who specialises in turbocharged RAM Trucks engines will know the common failure patterns for your specific engine and address them proactively. VVT and variable-geometry turbo systems (common on modern RAM Trucks engines) should be cleaned as part of the job.

Quality aftermarket turbos are appropriate for most RAM Trucks engines. Garrett, BorgWarner, IHI, Mitsubishi Turbo and Borg are the leading manufacturers and supply many OEM applications. Quality remanufacturers balance the rotating assembly and use OEM-specification bearings and seals. After fitting any remanufactured or aftermarket turbo, the oil feed and return lines must be cleaned or replaced, fresh oil fitted, and the engine run at idle for 5 minutes before driving — this primes the turbo bearings before full boost is applied. Skipping this break-in procedure is the leading cause of early remanufactured turbo failure.

Both cause power loss and a check engine light, but a boost leak is a much cheaper fix. Boost leaks occur at pipe connections, intercooler end caps or hose joints — they hiss or whistle under load and can often be found by pressurising the intake system with the engine off. A failing turbo typically shows blue or white smoke, unusual bearing noise (whine, siren-like sound at boost), or internal shaft play detectable by hand. A boost pressure test or smoke test of the intake system should be performed before condemning the turbo — many vehicles sent for turbo replacement simply have a split boost hose.

At 3–8 hours of labour this is a substantial repair requiring specialist knowledge, proper lifting equipment and workspace. Professional completion is strongly recommended — use RepairFair's estimate to confirm the quote is fair before committing.